|
|
|
#1
09-15-2011, 09:46 AM
|
|||
|
|||
bench or bucket?
ok guys and gals my chevelle came with bucket seats i have the bucket seats but not sure if i want to even use them. they are in BAD shape and everything needs to be replaced. a buddy of mine has a bench seat just dirty and its out of a 68 i was thinking about getting them but i am not sure what i should do. so i ask what would you guys do get the bench seat or take the time and money to restore the front buckets?
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress 
|
|
#2
09-15-2011, 10:32 AM
|
||||
|
||||
|
I think that it is personal preference. When I got mine it had the bench seat that was totally trashed, plus we had a set of bucket seats. I went with the buckets, but in some ways I wish that I had kept the bench.
I think it comes down to what are you looking for in seating? I think that the buckets make it a sportier look, and maybe more stability in the seat. The bench gives you more room for passengers, and more chance of getting that special someone right beside you in the seat as you go out for a cruise. In 69 you still had only the lap belt, so I would think about that, especially if you are planning on putting any power under the hood. Are you going with a more original look? There are so many things to consider, and only you can answer those questions. I will tell you that from my experience, spend the money now, because ultimately if you are not happy with the cheaper route, you will spend the money anyway. Just my 2 cents.
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org
|
|
#3
09-15-2011, 11:00 PM
|
||||
|
||||
|
If the frames are solid they can be used. I took mine apart had them sand blasted and expoyed primered them and painted them . If your springs are ok you can used them and just buy new foam and covers. I replaced mine because of broken springs. It wasn't that bad to redo them. I think the springs are $70 each and the foam run about $130 for both seats. Buckets is the only way to go for me. You can put the covers on yourself also.
   
__________________
Ray 1970 SS Chevelle Van Nuys Built Last edited by shadowgray396; 09-15-2011 at 11:02 PM.
|
|
#5
10-05-2011, 12:17 PM
|
|||
|
|||
|
Yea i was just being lazy and not wanting to do both seats! but i am going to stick to it only because i have the center console but my wife likes the idea of having the bench for more room but then she was thinking it might be a little harder to look back when my daughter is sitting in the back seat. so i am not sure yet. i am going to finish the rear seat in the next month and then we shall see
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress
|
|
#6
10-05-2011, 03:44 PM
|
||||
|
||||
|
The floor mounts for a bench seat are not the same as for buckets so it's not a direct swap. You would have to weld in new mounts.
I did my buckets, foam was good, had to replace some springs and new covers. I wouldn't call it a simple job putting on the new covers but you can do it. Last edited by Hank70SS; 10-06-2011 at 07:10 AM.
|
|
#9
10-06-2011, 06:57 PM
|
|||
|
|||
|
Holy crap,Ray.Them seat frames are awesome.
 I you go with the bench,then your lady can sit real close to you.Sometimes I wish I had the bench,Avis is so far away.
|
|
#10
10-18-2012, 11:14 AM
|
|||
|
|||
|
I'll trade me bench for buckets anyday!!
__________________
72 Chevelle Malibu Convertible 72 Impala Custom
|
 |
|
|
Linear Mode
